Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Tomball, TX

Extension Spring Replacement in Tomball, TX

Side-mounted extension springs replaced in matched pairs, with safety cables installed. Typical cost $150-$350.

From the first phone call to the final safety test, extension spring replacement in Tomball, TX follows a simple process: diagnose, quote, repair, test. Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for extension spring replacement

  • A stretched, sagging or snapped spring along one of the horizontal tracks
  • The door lifts unevenly or sits crooked
  • A missing or broken safety cable through the spring
  • Pulleys squealing or wobbling

What usually causes it

  • Metal fatigue from years of stretching
  • Rust and worn pulleys
  • Mismatched springs from an earlier repair

Safe checks before you call

  • Make sure each extension spring has a safety cable running through it. That cable keeps a snapped spring from flying across the garage.
  • Look at the pulleys and cables for fraying.
  • Don't try to stretch or re-hook an extension spring under tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our extension spring replacement process

  1. Open the door fully and secure it so spring tension is released
  2. Replace both springs as a matched pair, color-coded for door weight
  3. Replace worn pulleys and lift cables if needed
  4. Install or replace the safety containment cables
  5. Balance the door and test it through several cycles

Extension Spring Replacement cost in Tomball, TX

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Extension Spring Replacement in Tomball, TX

Humidity in Texas puts a thin layer of rust on spring coils, and that friction wears springs out early. Coated or galvanized springs last noticeably longer here.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Technicians serve all of Tomball (ZIP codes 77375 and 77377), plus Pinehurst (6.5 mi), The Woodlands (8.7 mi), Cypress (10.1 mi) and Oak Ridge North (11.1 mi). Call (833) 435-8883 to book a visit in Tomball.

Extension Spring Replacement: frequently asked questions

How much does extension spring replacement cost in Tomball, TX?

Extension Spring Replacement typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do extension spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is extension spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Texas or Tomball requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Tomball, TX

Ryobi Garage Door Opener Repair

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $125-$350

Sommer Garage Door Sensor Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $100-$250

Overhead Door Garage Door Opener Installation

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $350-$800

Amarr Off-Track Garage Door Repair

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $175-$450

Insulated Garage Door Installation

Polystyrene and polyurethane insulated doors that cut noise and temperature swings.

Typical $1,500-$5,000

Richards-Wilcox Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Overhead Door Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Hörmann Garage Door Sensor Repair

Photo-eye sensors realigned, rewired or replaced so the door closes reliably.

Typical $100-$250

CHI Overhead Doors Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Genie Smart Garage Door Opener Setup

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $100-$900

Craftsman Remote & Keypad Programming

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $50-$150

Martin Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Tomball, TX now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote